hit counter script
Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Honeywell Manuals
  4. Heater
  5. HZ-1350 Series
  6. Important safety instructions manual

Honeywell HZ-1350 Series Important Safety Instructions Manual page 3

Ceramic heater with thermostat control
Hide thumbs

Advertisement

Available languages

Available languages

SET UP
Place the heater on a firm, level, open surface free from obstructions and at least 3 feet (0.9m) away from
any wall or combustible material
DO NOT
use on an unstable surface such as bedding or deep carpeting.
BE SURE THE HEATER IS NOT IN A POSITION WHERE IT MAY BE TRIPPED OVER BY CHILDREN OR PETS.
OPERATION
NOTE: NEVER LEAVE AN OPERATING UNIT UNATTENDED
• With the POWER KNOB in the Off (•) position, plug the heater
into a polarized 120V outlet. DO NOT FORCE THE POLARIZED
PLUG INTO THE OUTLET; it will only fit one way.
• The POWER KNOB is equipped with two (2) settings
plus a fan setting:
1) Fan (
) - this setting uses the unit as an air circulator
without heat
2) Low (
) - this setting uses 900 watts of power
3) High (
) - this setting uses 1500 watts of power
NOTE: Because the LOW (
electricity to operate, it is more energy efficient and may be a better option if you are concerned about
saving energy.
• Turn heater on by turning the POWER KNOB to either LOW (
on.
• For FAN only operation, turn the selector knob to FAN (
The unit will work as an air circulator without heat.
• To disconnect heater, turn POWER KNOB to the OFF (•) position and unplug the heater when you are
finished using it.
THERMOSTAT
To set the Thermostat, turn the Thermostat Control fully to the
highest setting (
)
When the room reaches a comfortable temperature, slowly turn the
Thermostat Control towards (
and fan go off (the Power Light will remain on). This is the point at
which the Thermostat setting equals the room temperature. At this
setting, the Thermostat will automatically turn the heater back on
and then off as needed to maintain the selected temperature.
Turn the POWER KNOB to OFF (•) and unplug the heater when you
are finished using it.
) setting does not require as much
) until both the heating element
) or HIGH (
), the power light will come
) and turn the thermostat to its highest setting.
Decrease Temperature
Increase Temperature
3

Advertisement

loading

Related Manuals for Honeywell HZ-1350 Series

Related Products for Honeywell HZ-1350 Series