Siemens SINUMERIK 840D Series Diagnostics Manual page 400
Hide thumbs
Also See for SINUMERIK 840D Series:
- Function manual (920 pages) ,
- Diagnostics manual (714 pages) ,
- Operating turning (713 pages)
Table of Contents
Advertisement
1 Alarms
Reactions:
Remedy:
Program Continuation:
61316
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61332
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61338
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61601
Parameters:
Definitions:
1-400
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Select the tool's tool edge number D.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 center point and radius cannot be determined.
%1 = Channel number
%2 = Block number, label
No circle can be calculated from the measured points, as all measured points lie on a
straight line.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Program change
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 change tool tip position
%1 = Channel number
%2 = Block number, label
The tool tip is below the measuring probe surface (e.g. for a ring gauge or cube).
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Place the tool above the measuring probe surface.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 positioning velocity is zero
%1 = Channel number
%2 = Block number, label
For some measuring versions, e.g. measuring spigots, in addition to the actual measuring
paths, intermediate paths were generated that are traversed with a specified feed.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Set the appropriate feed (plane feed/infeed) via MD 9757 or 9758.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 finished-part diameter too small
%1 = Channel number
%2 = Block number, label
An incorrect finished-part diameter has been programmed. Alarm triggered by following
cycles: CYCLE94, CYCLE96.
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Siemens AG, 2002. All rights reserved
11.02
Hide quick links:
Advertisement
Table of Contents
