Siemens SINUMERIK 840D Series Diagnostics Manual page 453
Hide thumbs
Also See for SINUMERIK 840D Series:
- Function manual (920 pages) ,
- Diagnostics manual (714 pages) ,
- Operating turning (713 pages)
Table of Contents
Advertisement
11.02
112200
Definitions:
Reactions:
Remedy:
Program Continuation:
112201
Definitions:
Reactions:
Remedy:
Program Continuation:
112210
Definitions:
Reactions:
Remedy:
Program Continuation:
112211
Definitions:
Reactions:
Remedy:
Program Continuation:
112300
Definitions:
Reactions:
Remedy:
Program Continuation:
Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
The contour is a step in the current program sequence. Machining not enabled
The contour is an element from a loaded program and cannot be deleted or renamed.
- Alarm display.
Remove the contour from the loaded program.
Internal
The contour is a step in the current automatic sequence. Machining not enabled
The contour is an element of a program loaded under "Machine auto" and cannot be
deleted or renamed.
After the program has been started, the integrated contours cannot be changed under
"Program" while the program is running.
- Alarm display.
Stop the program and load it under "Program". Remove the contour from the program.
Internal
Tool axis cannot be switched over. Insufficient NC memory.
If the tool axis is reselected, the NC program has to be generated again. Hereby the old
NC program is saved first.
Then the new program is generated. Here, the NC memory is insufficient to save the new
program.
The reselection of the tool axis was not carried out.
- Alarm display.
Free memory space must be created on the NC, and it must be enough for the program to
be processed (e.g. by deleting programs that are no longer required).
Internal
Tool preselection could not be processed. Insufficient NC memory.
When tool preselection is processed, the NC program has to be generated again. Hereby
the old NC program is saved first.
Then the new program is generated. Here, the NC memory is insufficient to save the new
program.
The tool preselection is not processed.
- Alarm display.
Free memory space must be created on the NC, and it must be enough for the program to
be processed (e.g. by deleting programs that are no longer required).
Internal
Tool management type 2 not possible. Magazine not completely loaded.
The magazine is not completely loaded with tools.
In the magazine of tool management type 2, the number of tools specified in machine
data 18082 has to be created.
- Alarm display.
Installation and start-up: Create the correct number of tools.
Internal
1 Alarms
1-453
Hide quick links:
Advertisement
Table of Contents
