Siemens SINUMERIK 840D Series Diagnostics Manual page 66
Hide thumbs
Also See for SINUMERIK 840D Series:
- Function manual (920 pages) ,
- Diagnostics manual (714 pages) ,
- Operating turning (713 pages)
Table of Contents
Advertisement
1 Alarms
Reactions:
Remedy:
Program Continuation:
6421
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
6422
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
6423
Parameters:
Definitions:
1-66
The actual type of tool monitoring is a tool property (see $TC TP9).
If replacement tools are not being used, the duplo number specified has no meaning.
The alarm originates during NC program execution.
- Alarm display.
- Interface signals are set.
For information only. The user must decide what to do.
Clear alarm with the Delete key or NC START.
Channel %1 tool move not possible. Empty location for tool %2 Duplo no. %3 on
magazine %4 not available.
%1 = Channel ID
%2 = String (identifier)
%3 = Duplo number
%4 = Magazine number
The desired tool motion command - triggered from the MMC or PLC - is not possible. The
tool cannot be moved into the specified tool magazine. There is no appropriate location
for this tool.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
• Check whether the magazine data have been defined correctly (e.g. the magazine must
not be disabled).
• Check whether the tool data are correctly defined (for example, the tool location type
must match the location types allowed in the magazine).
• Check whether there is still room in the magazine to add another tool; there may not be
due to operating procedures.
• Check whether a location type hierarchy is defined and whether it, for example, does
not allow insertion of a type 'A' tool in a free location with type 'B'.
Clear alarm with the Delete key or NC START.
Channel %1 tool move not possible. Magazine no. %2 not available.
%1 = Channel ID
%2 = Magazine number
The desired tool motion command - triggered from the MMC or PLC - is not possible. The
magazine with the specified number is not available.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
• Check whether the magazine data have been defined correctly.
• If the PLC issued the command for motion: check whether the PLC program is correct.
• If the MMC issued the command for motion: check whether the MMC command was
assigned correct parameters.
Clear alarm with the Delete key or NC START.
Channel %1 tool move not possible. Location %2 on magazine %3 not available.
%1 = Channel ID
%2 = Magazine location number
%3 = Magazine number
The desired tool motion command - triggered from the MMC or PLC - is not possible. The
specified magazine location is not contained in the specified magazine.
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Siemens AG, 2002. All rights reserved
11.02
Hide quick links:
Advertisement
Table of Contents
