Siemens SINUMERIK 840D Series Diagnostics Manual page 180
Hide thumbs
Also See for SINUMERIK 840D Series:
- Function manual (920 pages) ,
- Diagnostics manual (714 pages) ,
- Operating turning (713 pages)
Table of Contents
Advertisement
1 Alarms
14159
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14160
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14165
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14170
Parameters:
Definitions:
Reactions:
1-180
Channel %1 block %2 more than two angles programmed with ROTS or AROTS
%1 = Channel number
%2 = Block number, label
Frame rotations are described using space angles with the language commands ROTS or
AROTS. A maximum of two angles can be programmed.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
- Interpreter stop
Modify program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 tool length selection without geometry axis specification
%1 = Channel number
%2 = Block number, label
If variant C (tool length acts on the programmed axis) is activated by machine data
$MC_TOOL_CORR_MODE for tool length compensation with H word and G43/G44 in
ISO_2 mode, at least one geometry axis must be specified.
- Local alarm reaction.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
- NC Stop on alarm at block end.
Change machine data $MC_TOOL_CORR_MODE or the part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 active T number does not match selected tool
%1 = Channel number
%2 = Block number, label
When an H or D number is programmed in ISO_2 mode, the T number used in the defini-
tion for this tool is determined. This number must be identical to the T number pro-
grammed explicitly.
- Local alarm reaction.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
- NC Stop on alarm at block end.
Change machine data $MC_TOOL_CORR_MODE or the part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 illegal interpolation type with tool length compensation
%1 = Channel number
%2 = Block number, label
If tool compensation (G43/G44) is activated in language mode ISO_2, the linear type of
interpolation must be active.
- Local alarm reaction.
- Alarm display.
- Interface signals are set.
- Correction block is reorganized.
- NC Stop on alarm at block end.
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Siemens AG, 2002. All rights reserved
11.02
Hide quick links:
Advertisement
Table of Contents
