Siemens SINUMERIK 840D Series Diagnostics Manual page 378
Hide thumbs
Also See for SINUMERIK 840D Series:
- Function manual (920 pages) ,
- Diagnostics manual (714 pages) ,
- Operating turning (713 pages)
Table of Contents
Advertisement
1 Alarms
Definitions:
Reactions:
Remedy:
Program Continuation:
61009
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61010
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61011
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61012
Parameters:
Definitions:
1-378
The tool radius is too small for machining. Alarm triggered by following cycles: CYCLE92,
E_CP_CO, E_SL_CIR, F_CP_CO, F_PARTOF, F_SL_CIR.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Select a larger tool.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 active tool number = 0
%1 = Channel number
%2 = Block number, label
No tool (T) has been programmed before the cycle call. Alarm triggered by following
cycles: CYCLE71, CYCLE72.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Program tool (T).
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 finishing allowance too large
%1 = Channel number
%2 = Block number, label
The finishing allowance for the base is greater than the total depth. Alarm triggered by fol-
lowing cycle: CYCLE72.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Reduce finishing allowance.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 scaling not allowed
%1 = Channel number
%2 = Block number, label
A scale factor is active which is illegal for this cycle. Alarm triggered by following cycles:
CYCLE71, CYCLE72.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Modify scale factor.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 different scaling on the plane
%1 = Channel number
%2 = Block number, label
Alarm triggered by following cycles: CYCLE76, CYCLE77.
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Siemens AG, 2002. All rights reserved
11.02
Hide quick links:
Advertisement
Table of Contents
