Siemens SINUMERIK 840D Series Diagnostics Manual page 590
Hide thumbs
Also See for SINUMERIK 840D Series:
- Function manual (920 pages) ,
- Diagnostics manual (714 pages) ,
- Operating turning (713 pages)
Table of Contents
Advertisement
1 Alarms
Error code
Extension 1
Extension 2
Explanation
Remedy
Error code
Extension 1
Extension 2
Explanation
Remedy
Error code
Extension 1
Extension 2
Explanation
Remedy
Error code
Extension 1
Extension 2
Explanation
Remedy
1-590
0004H
-
-
Upon servo enable, the NC must update the sign-of-life monitoring in each position con-
trol cycle. In case of error, sign-of-life monitoring has not been updated for at least two
consecutive position control cycles.
Causes: NC failure, communication failure on the drive bus. Hardware error on drive mod-
ule or hardware error on NC CPU if error occurs sporadically at intervals of several hours.
Other cause: Ring programming for GI (gear interpolation) and gantry axes.
Check cable connections, perform remedial measures (check shielding or ground con-
nection). Replace the NC hardware, replace the control module. Replace the NC CPU
with the "VB" version, replace the control module.
0005H
1A : DS
<> 1 if CS = 0
2A : DS
<> 1, 2, 3, 4, 5
2B : DS-CS <> 0, 1
2C : DS = 3 on PO parameterization error
3A : DS
<> 1, 2, 3, 4, 5
3B : DS-CS <> 0, 1
-
The power-up of the drive modules is grouped into 5 states (steps). The states are speci-
fied consecutively by the NC and acknowledged by the drive. An error occurs when an
invalid specified state is detected in the drive.
Causes: Communication failure on the drive bus. Hardware error on the drive module,
hardware error on the NC.
Check cable connections, perform remedial measures (check shielding or ground con-
nection). Replace the control module, replace the NC hardware.
0006H
-
-
The infinite loop for processing communication has been exited. The cause is probably a
hardware error on the control module.
Replace the control module.
0007H
-
-
An illegal state was read by the hardware during the cycle synchronization of the NC and
the drive. Synchronization could not be performed.
Replace the control module.
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
Siemens AG, 2002. All rights reserved
11.02
Hide quick links:
Advertisement
Table of Contents
