Siemens SINUMERIK 840D Diagnostics Manual page 126
Hide thumbs
Also See for SINUMERIK 840D:
- Function manual (920 pages) ,
- Operating turning (713 pages) ,
- Diagnostics manual (622 pages)
Table of Contents
Advertisement
1 Alarms
10820
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10860
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10861
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1-126
Channel %1 rotary axis/spindle %2 not defined
%1 = Channel number
%2 = Axis name, spindle number
Revolutional feed has been programmed for contouring and synchronous axes or for an
axis/spindle. However, the rotary axis/spindle from which the feed is to be deduced is not
available.
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
Correct part program or set the setting data 43300 ASSIGN_FEED_PER_REV_SOURCE
correctly.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 feedrate not programmed
%1 = Channel number
%2 = Block number, label
Reason:
In the displayed block, an interpolation type other than G00 (rapid traverse) is active. The
F value has not been programmed.
Path feed F is active, on change between linear and revolutional feedrate, F has not been
programmed again.
The modal feed for corner/chamfer (FRCM) is active, on change between linear and revo-
lutional feedrate FRCM has not been programmed again.
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
Program feedrate in accordance with the interpolation type.
• G93: The feedrate is specified as a time-reciprocal value under address F in [1/min].
• G94 and G97: The feedrate is programmed under address F in [mm/min] or [m/min].
• G95: The feedrate is programmed as revolutional feedrate under address F in [mm/rev-
olution].
• G96: The feedrate is programmed as cutting rate under address S in [m/min]. It is
derived from the current spindle speed.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %3 velocity of positioning axis %2 is zero
%1 = Channel number
%2 = Axis
%3 = Block number, label
No axis velocity has been programmed and the positioning velocity set in the machine
data is zero.
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
Please inform the authorized personnel/service department. Enter a different velocity in
machine data 32060 MA_POS_AX_VELO.
Clear alarm with NC START or RESET key and continue the program.
Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04
Hide quick links:
Advertisement
Table of Contents
