Siemens SINUMERIK 840D Diagnostics Manual page 242
Hide thumbs
Also See for SINUMERIK 840D:
- Function manual (920 pages) ,
- Operating turning (713 pages) ,
- Diagnostics manual (622 pages)
Table of Contents
Advertisement
1 Alarms
Reactions:
Remedy:
Program Continuation:
15360
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
15370
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
15380
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
15390
Parameters:
Definitions:
1-242
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Check the part program, change the block search (typing error in the part program) and
restart the search.
Clear alarm with the RESET key. Restart part program.
Channel %1 illegal target of block search (syntax error)
%1 = Channel number
The specified search target (block number, label or string) is not allowed in block search.
- Alarm display.
Correct target of block search.
Clear alarm with the Delete key or NC START.
Channel %1 target of block search not found
%1 = Channel number
In a block search, an impermissible search target has been specified (e.g. negative block
number).
- Alarm display.
Check the specified block number, label or character string. Repeat entry with correct
search target.
Clear alarm with the Delete key or NC START.
Channel %1 block %2 illegal incremental programming in axis %3
%1 = Channel number
%2 = Block number, label
%3 = Axis
The first axis programming after "search to block end point" is performed incrementally.
This is not allowed in the following situations:
• After searching the target a transformation change has taken place.
• A frame with rotation component is active. The programmed axis is involved in the rota-
tion.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
• Find search destination in which the axes are programmed using an absolute reference.
• Deactivate adding of the accumulated search position with
$SC_TARGET_BLOCK_INCR_PROG = FALSE.
• Use search run with calculation "at contour".
Clear alarm with the RESET key. Restart part program.
Channel %1 block %2 %3 not executed during block search
%1 = Channel number
%2 = Block number, label
%3 = Source symbol
During block search, commands for switching, deleting and defining of the electronic gear
are not executed and not gathered but simply skipped.
Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04
Hide quick links:
Advertisement
Table of Contents
