Siemens SINUMERIK 840D Diagnostics Manual page 434
Hide thumbs
Also See for SINUMERIK 840D:
- Function manual (920 pages) ,
- Operating turning (713 pages) ,
- Diagnostics manual (622 pages)
Table of Contents
Advertisement
1 Alarms
61215
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61216
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61217
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61218
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1-434
Channel %1 block %2 raw dimension incorrectly programmed
%1 = Channel number
%2 = Block number, label
Alarm triggered by following cycle: CYCLE76, CYCLE77.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
--
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 feed/tooth only possible with milling tools
%1 = Channel number
%2 = Block number, label
Feed per tooth is only possible with milling tools. Alarm triggered by following cycles:
E_TFS, F_TFS.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
As alternative, set a different feed type.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 cutting speed for tool radius 0 programmed
%1 = Channel number
%2 = Block number, label
To be able to work with cutting speed, the tool radius has to be specified. Alarm triggered
by following cycles: E_TFS, E_DR_TAP, F_TFS, F_DR_TAP.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Enter a value for cutting speed.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 feed/tooth programmed, but number of teeth is zero
%1 = Channel number
%2 = Block number, label
For feed per tooth, the number of teeth has to be specified. Alarm triggered by following
cycles: E_TFS, E_DR_BGF, F_TFS.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Enter the number of teeth on the milling tool in the "Tool list" menu.
Clear alarm with the RESET key. Restart part program
Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04
Hide quick links:
Advertisement
Table of Contents
