Siemens SINUMERIK 840D Diagnostics Manual page 120
Hide thumbs
Also See for SINUMERIK 840D:
- Function manual (920 pages) ,
- Operating turning (713 pages) ,
- Diagnostics manual (622 pages)
Table of Contents
Advertisement
1 Alarms
Reactions:
Remedy:
Program Continuation:
10777
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10778
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10779
Parameters:
Definitions:
1-120
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Modify part program.
On selection of G41/42, the axes involved must be known as GEOAX in the channel. It is
possible by programming GEOAX() or G91 G0 X0 Y0 in the block prior to G41/42.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 tool radius compensation: too many blocks with suppression
of compensation
%1 = Channel number
%2 = Block number, label
The maximum permissible number of blocks with active compensation suppression with
tool radius compensation is limited by the machine data
CUTCOM_MAXNUM_SUPPR_BLOCKS.
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
• Modify part program.
• Modify machine data.
• Check whether SBL2 is activated. With SBL2, a block is generated from each part pro-
gram line which can lead to exceeding the maximum permissible number of empty blocks
between two traversing blocks.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 preprocessing stop with active tool radius compensation
%1 = Channel number
%2 = Block number, label
If a preprocessing stop is detected with active tool radius compensation (either pro-
grammed by the user or generated internally) and the setting data
$SC_STOP_CUTCOM_STOPRE is set, then this warning is issued because in this situa-
tion machine movements which were not intended by the user can occur (termination of
radius compensation and new approach).
- Alarm display.
- NC Stop on alarm at block end.
• Continue machining with CANCEL and Start.
• Modify part program.
• Set setting data $SC_STOP_CUTCOM_STOPRE to FALSE.
Clear alarm with the Delete key or NC START.
Channel %1 block %2 preprocessing stop with active tool radius compensation
%1 = Channel number
%2 = Block number, label
If a preprocessing stop is detected with active tool radius compensation (either pro-
grammed by the user or generated internally) and the setting data
$SC_STOP_CUTCOM_STOPRE is set, then this warning is issued because in this situa-
tion machine movements which were not intended by the user can occur (termination of
radius compensation and new approach).
To continue machining, activate the CANCEL key and perform a restart.
Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04
Hide quick links:
Advertisement
Table of Contents
