Siemens SINUMERIK 840D Diagnostics Manual page 123
Hide thumbs
Also See for SINUMERIK 840D:
- Function manual (920 pages) ,
- Operating turning (713 pages) ,
- Diagnostics manual (622 pages)
Table of Contents
Advertisement
10.04
10790
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10791
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10792
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10793
Parameters:
Definitions:
Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Channel %1 block %2 plane change during linear programming with angles
%1 = Channel number
%2 = Block number, label
The active plane was changed between the first and second subblock when programming
two straight lines with angle parameters.
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 invalid angle during linear programming
%1 = Channel number
%2 = Block number, label
No intermediate point was found when programming a contour consisting of two straight
lines and an angle specification.
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 illegal interpolation type during linear programming with
angles
%1 = Channel number
%2 = Block number, label
Only spline or linear interpolation is permitted for programming two straight lines with
angle specification. Circular or polynomial interpolation is not allowed.
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 second block missing during linear programming with
angles
%1 = Channel number
%2 = Block number, label
The second block is missing during programming of two straight lines with angle specifi-
cation. This situation only occurs if the first subblock is also the last block of a program, or
if the first subblock is followed by a block with a preprocessor stop.
1 Alarms
1-123
Hide quick links:
Advertisement
Table of Contents
