Siemens SINUMERIK 840D Diagnostics Manual page 202
Hide thumbs
Also See for SINUMERIK 840D:
- Function manual (920 pages) ,
- Operating turning (713 pages) ,
- Diagnostics manual (622 pages)
Table of Contents
Advertisement
1 Alarms
Reactions:
Remedy:
Program Continuation:
14198
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14199
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
14200
Parameters:
Definitions:
1-202
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 illegal change of tool direction with tool offset
%1 = Channel number
%2 = Block number, label
If an offset is active in the tool direction, block change is not possible if this would change
the assignment of the offset axes to the channel axes (plane change, tool change, cutter
<=> turning tool, geometry axis replacement).
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
• Modify part program.
• Reduce the offset in tool direction to zero.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 illegal plane change for tool with diameter component
%1 = Channel number
%2 = Block number, label
If a tool has a wear or length component which is evaluated as a diameter for the facing
axis (bit 0 and/or bit 1 in MD $MC_TOOL_PARAMETER_DEF_MASK is set) and bit 2 of
this MD is also set, this tool may only be used in the plane active on tool selection. A
plane change results in an alarm.
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
• Modify part program.
• Reset bit 2 in MD $MC_TOOL_PARAMETER_DEF_MASK.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 negative polar radius
%1 = Channel number
%2 = Block number, label
In the endpoint specification of a traversing block with G00, G01, G02 or G03 in polar
coordinates, the polar radius entered for the keyword RP=... is negative.
Definition of terms:
• Specification of end of block point with polar angle and polar radius, referring to the cur-
rent pole (preparatory functions: G00/G01/G02/G03).
• New definition of the pole with polar angle and pole radius, referring to the reference
point selected with the G function. G110 ... last programmed point in the plane, G111 ...
zero point of the current work, G112 ... last pole
Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04
Hide quick links:
Advertisement
Table of Contents
