Siemens SINUMERIK 840D Diagnostics Manual page 264
Hide thumbs
Also See for SINUMERIK 840D:
- Function manual (920 pages) ,
- Operating turning (713 pages) ,
- Diagnostics manual (622 pages)
Table of Contents
Advertisement
1 Alarms
Reactions:
Remedy:
Program Continuation:
16789
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16790
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16791
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16792
Parameters:
1-264
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Please inform the authorized personnel/service department.
• Configure link accordingly in MD (channel MD: 21300 COUPLE_AXIS_n)
• or modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 multiple link
%1 = Channel number
%2 = Block number, label
A coupling has been switched on in which the axes/spindles have already been assigned
by another coupling. Parallel couplings cannot be processed.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Check in the part program whether another link already exists for the axes.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 Parameter is zero or missing
%1 = Channel number
%2 = Block number, label
A coupling has been switched on in which a relevant parameter has been specified with
zero or has not been written (e.g. denominator in the transmission ratio, no slave axis).
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Please inform the authorized personnel/service department.
• Configure link accordingly in MD (channel MD: 42300 COUPLE_AXIS_n)
• or modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 parameter is not relevant
%1 = Channel number
%2 = Block number, label
A coupling has been switched on in which a non-relevant parameter has been written
(e.g. parameter for ELG).
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 too many couplings for axis/spindle %3
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04
Hide quick links:
Advertisement
Table of Contents
