Siemens SINUMERIK 840D Diagnostics Manual page 282
Hide thumbs
Also See for SINUMERIK 840D:
- Function manual (920 pages) ,
- Operating turning (713 pages) ,
- Diagnostics manual (622 pages)
Table of Contents
Advertisement
1 Alarms
Reactions:
Remedy:
Program Continuation:
16954
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16955
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16956
Parameters:
Definitions:
1-282
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Set axis/spindle disable of the master axis
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 programmed stop prohibited in stop delay area
%1 = Channel ID
%2 = Block number, label
In a program area (stop delay area) that is bracketed with DELAYFSTON and DELAYF-
STOF, a program command was used that causes a stop.
No commands other than G4 are permissible that might cause a stop even though only
shortly.
A stop delay area can also be defined by
$MN_STOP_MODE_MASK.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
$MN_STOP_MODE_MASK and language command DELAYFSTON DELAYFSTOF
Clear alarm with the RESET key. Restart part program
Channel %1 stop in stop delay area is delayed
%1 = Channel ID
In a program area (stop delay area) that is bracketed by DELAYFSTON and DELAYF-
STOF,
an event has been detected that causes a stop. The stop is delayed
and executed after DELAYFSTOF. A stop delay area can also be defined by
$MN_STOP_MODE_MASK.
- Interface signals are set.
- Alarm display.
$MN_STOP_MODE_MASK and language command DELAYFSTON DELAYFSTOF
Alarm display showing cause of alarm disappears. No further operator action necessary.
Channel %1 program %2 cannot be started due to global start disable.
%1 = Channel ID
%2 = String (path with program name)
The program selected in this channel cannot be started as "Global start disable" had been
set.
Note:
PI "_N_STRTLK" sets the "Global start disable" and PI "_N_STRTUL"
deletes the "Global start disable".
The alarm is switched on with $MN_ENABLE_ALARM_MASK bit 6.
Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04
Hide quick links:
Advertisement
Table of Contents
