Siemens SINUMERIK 840D Diagnostics Manual page 334
Hide thumbs
Also See for SINUMERIK 840D:
- Function manual (920 pages) ,
- Operating turning (713 pages) ,
- Diagnostics manual (622 pages)
Table of Contents
Advertisement
1 Alarms
Remedy:
Program Continuation:
20203
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
20204
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
20210
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
20211
Parameters:
1-334
1. Modify the part program (write the tool fine compensation).
2. Establish spindle/tool assignment by programming:
• TMON (tool monitoring)
• GWPSON (tool selection)
Clear alarm with the RESET key. Restart part program
Channel %1 no active tool
%1 = Channel number
A tool fine compensation has been written for the active tool of channel %1 with PUTF-
TOC. No tool is active in this channel. Therefore, the compensation cannot be assigned.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Correct the program.
Clear alarm with the RESET key. Restart part program
Channel %1 PUTFTOC command not allowed with FTOCOF
%1 = Channel number
A tool fine compensation has been written for channel %1 with PUTFTOC. The tool fine
compensation is not active in this channel. FTOCON must be active in the target channel
of the PUTFTOC command.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Correct the program in the machining channel: Select FTOCON so that the channel is
ready to receive the PUTFTOC command.
Clear alarm with the RESET key. Restart part program
Channel %1 block %3 spindle %2 wrong values for centerless grinding
%1 = Channel number
%2 = Spindle number
%3 = Block number, label
It was not possible to calculate a tool diameter (no speed specified for the spindle) for
centerless grinding because it was not allowed by the input positions. The old S value still
applies.
- Alarm display.
• Modify program
• Select new traversing positions for centerless axes
• or suppress computation by G00.
Alarm display showing cause of alarm disappears. No further operator action necessary.
Channel %1 block %3 spindle %2 support point beyond range limits
%1 = Channel number
%2 = Spindle number
%3 = Block number, label
Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04
Hide quick links:
Advertisement
Table of Contents
