Siemens SINUMERIK 840D Diagnostics Manual page 435
Hide thumbs
Also See for SINUMERIK 840D:
- Function manual (920 pages) ,
- Operating turning (713 pages) ,
- Diagnostics manual (622 pages)
Table of Contents
Advertisement
10.04
61222
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61223
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61224
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61225
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Channel %1 block %2 plane infeed greater than the tool diameter
%1 = Channel number
%2 = Block number, label
The plane infeed must not be greater than the tool diameter. Alarm triggered by following
cycles: CYCLE79, E_PO_CIR, E_PO_REC, F_PO_CIR, F_PO_REC.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Reduce plane infeed.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 approach path too short
%1 = Channel number
%2 = Block number, label
The approach path must not be less than zero. Alarm triggered by following cycles:
E_MI_CON, F_MI_CON.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Enter a greater value for the approach path.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 retract path too short
%1 = Channel number
%2 = Block number, label
The retract path must not be less than zero. Alarm triggered by following cycles:
E_MI_CON, F_MI_CON.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Enter a greater value for the retract path.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 swivel data block unknown
%1 = Channel number
%2 = Block number, label
An attempt was made to access a swivel data block which has not been defined.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Select another swivel data block or define a new swivel data block.
Clear alarm with the RESET key. Restart part program
1 Alarms
1-435
Hide quick links:
Advertisement
Table of Contents
