Siemens SINUMERIK 840D Diagnostics Manual page 566
Hide thumbs
Also See for SINUMERIK 840D:
- Function manual (920 pages) ,
- Operating turning (713 pages) ,
- Diagnostics manual (622 pages)
Table of Contents
Advertisement
1 Alarms
300704
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
300705
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
300706
Parameters:
Definitions:
1-566
Axis %1 drive %2 speed controller cycle time invalid
%1 = NC axis number
%2 = Drive number
In the drive MD 1001: $MD_SPEEDCTRL_CYCLE_TIME.
- NC not ready.
- The NC switches to follow-up mode.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Please inform the authorized personnel/service department.
The following values are permissible:
611D control module Speed controller cycle
• Standard control as 1-axis: >= 125 µs
• Standard control as 2-axis: >= 500 µs
• Performance 1-axis: >= 62.5 µs (MSD >= 125 µs)
• Performance 2-axis: >= 125 µs
• 810D: >= 312.5 µs
• MCU: >= 125 µs
• Performance 2, 1-axis: >= 31.25 µs
• Performance 2, 2-axis: >= 62.5 µs
Switch control OFF - ON.
Axis %1 drive %2 position controller cycle time invalid
%1 = NC axis number
%2 = Drive number
The monitor in the 611D module has detected a position controller pulse rate which is
beyond the permissible limits. The conditions for a permissible position controller pulse
rate are:
1. Minimum cycle period: 250 µs (810D 312.5 µs)
2. Maximum pulse rate: 4 s
3. The position controller pulse rate must be a multiple of the speed controller cycle given
in the drive MD 1001: $MD_SPEEDCTRL_CYCLE_TIME.
- NC not ready.
- The NC switches to follow-up mode.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Change the position controller pulse rate on the NC.
Switch control OFF - ON.
Axis %1 drive %2 monitoring cycle time invalid
%1 = NC axis number
%2 = Drive number
Monitoring cycle MD 1002: $MD_MONITOR_CYCLE_TIME is invalid.
Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04
Hide quick links:
Advertisement
Table of Contents
