Creating And Using The Configuration File - Siemens SINUMERIK 840D sl Function Manual
Hide thumbs
Also See for SINUMERIK 840D sl:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
B3: Several operator panels connected to several NCUs, distributed systems - only 840D sl
2.2 Several operator panel fronts and NCUs with control unit management option
Element
ChanNum = i (i = 1, 2, 3,...)
And so on for all channels in
group
Continue with next group and its
channels
A complete example of how to configure the channel menu can be found in "Configuration
file NETNAMES.INI with the control unit management option".
2.2.5
Creating and using the configuration file
Syntax
The configuration file must be generated as an ASCII file. The syntax is the same as that
used in Windows *.ini files.
In particular, the following is applicable:
● Passwords must be typed in small letters.
● Comments can be inserted in the parameter file (limited on the left by ";" and on the right
● Blanks may be used as separators at any position except in identifiers and passwords.
HMI Embedded, OP030, HT6
The NETNAMES.INI file created on a PC or programming device is loaded, as described in
References: FBO/IK/ Configuration Operator Interface OP 030/Installation Kit
via the RS 232 interface and permanently stored in the FLASH memory of the control units.
HMI Advanced
The NETNAMES.INI file can be edited directly with an editor (in menu
"Commissioning/HMI/Editor" or DOS_SHELL) on the hard disk of the operator component.
The NETNAMES.INI file is stored in the installation directory C:\USER\.
Example
For a sample configuration file, see Section "Examples".
114
by end of line).
Explanation
Number of channel configured
for associated NCU (3.)
Function Manual, 09/2009, 6FC5397-1BP20-0BA0
Example
ChanNum = 1
Extended Functions
- Quick Links:
- Programming
Hide quick links:
Advertisement
Table of Contents
