Mitsubishi Electric MELSERVO-J5 User Manual page 234

Ac servo system

Hide thumbs Also See for MELSERVO-J5:

Table of Contents

4-d mounting hole

(Varnish is removed only from bottom right (face and back side))

Servo amplifier

Power factor

*1 Use this for grounding.

*2 When using the power factor improving DC reactor, remove the short-circuit bar between P3 and P4.

*3 Maximum dimensions. The dimensions vary depending on the curvature of the input/output lines.

*4 Selection requirements for the wire size are as follows.

Wire type: 600 V Grade heat-resistant polyvinyl chloride insulated wire (HIV wire)

Construction requirements: Single wire set in midair

6 OPTIONS AND PERIPHERAL EQUIPMENT

6.11 Power factor improving DC reactor

Dimensions [mm]

Servo amplifier

3.5 (AWG 12)

5.5 (AWG 10)