How To Replace Servo Amplifier Without Magnetic Pole Detection - Mitsubishi Electric MELSERVO-J5 User Manual
Ac servo system
Hide thumbs
Also See for MELSERVO-J5:
- User manual (580 pages) ,
- Sample screen manual (128 pages) ,
- Introduction manual (112 pages)
Table of Contents
Advertisement
How to replace servo amplifier without magnetic pole detection
When replacing the servo amplifier, carry out the magnetic pole detection again. If the magnetic pole detection cannot be
performed, write the magnetic pole information from the servo amplifier before replacement to the one after replacement by
using MR Configurator2.
Procedure
1.
Read the magnetic pole information of the servo amplifier before replacement.
2.
Write the read magnetic pole information to the servo amplifier after replacement.
3.
To ensure safety, perform the test operation with the torque limited and confirm that the servo motor can be operated
safely.
Migration method of the magnetic pole information
■How to read magnetic pole information from servo amplifier before replacement
1.
Open the project in MR Configurator2 and select the model.
2.
Check that the personal computer is connected with the servo amplifier, and select "Diagnosis" and then "Linear
diagnosis".
3.
Click "Magnetic Pole Information" to open the magnetic pole information window.
4.
Click "Read" in the magnetic pole information window.
5.
Note down the values shown in data 1 of the magnetic pole information window.
■How to write magnetic pole information to servo amplifier after replacement
1.
Open the project in MR Configurator2 and select the model.
2.
Check that the personal computer is connected with the servo amplifier, and select "Diagnosis" and then "Linear
diagnosis".
3.
Click "Magnetic Pole Information" to open the magnetic pole information window.
4.
To data 1 of the magnetic pole information window, input the values of the magnetic pole information which were noted
down.
5.
Click "Write" in the magnetic pole information window.
6.
Cycle the power of the servo amplifier.
10 USING A LINEAR SERVO MOTOR
10.2 Startup [G] [WG]
10
357
Advertisement
Table of Contents
