Mitsubishi Electric MELSERVO-J5 User Manual page 444

Ac servo system

Hide thumbs Also See for MELSERVO-J5:

Table of Contents

Assembly of the case

After all MR-BAT6V1 batteries are mounted, fit the cover and insert screws into the two holes and tighten them. Tightening

torque is 0.71 N•m.

Be careful not to trap the lead wires when installing the screws and re-installing the cover.

Precautions for removal of battery

The connector attached to the MR-BAT6V1 battery has the lock release lever. When removing the connector, pull out the

connector while pressing the lock release lever.

• Battery cable removal

• Pulling out the connector of the MR-BT6V1CBL and MR-BT6V2CBL without the lock release lever pressed may damage

the CN4 connector of the servo amplifier or the connector of the MR-BT6V1CBL or MR-BT6V2CBL.

11 USING A DIRECT DRIVE MOTOR

11.8 Battery

While pressing the lock release lever,

pull out the connector.

Battery cable