hit counter script
  1. Manuals
  2. Brands
  3. Mitsubishi Electric Manuals
  4. Controller
  5. CNC
  6. Specifications and instruction manual

Mitsubishi Electric CNC Specifications And Instruction Manual page 42

Direct drive motor
Hide thumbs
Table of Contents

Advertisement

Direct Drive Motor Specifications and Instruction Manual
2 Specifications
[ TM-RBP150G20 ]
Power supply lead : 3-AWG10 (Finish outer diameter
（U， V， W）
Thermistor lead : 2-AWG18 (Finish outer diameter
（MT1， MT2）
Ground lead : 1-AWG10 (Finish outer diameter
Lead-out range
Recommended inlet/outlet
of lead wire
position for cooling liquid
8-M6 screw
Depth 14
(Note 1) Do not move the stator by holding the lead wire.
(Note 2) Degree of protection is IP00. Use explosion-proof oil, etc., as necessary.
(Note 3) Continuous rated torque is assured only when the required cooling capacity is satisfied.
(Note 4) There is no problem on the functionality or performance even if the molded parts include sink marks or voids, etc.
[ TM-RBS150G20 ]
(Note 1) Deliverable rotors are magnetized. Please note the magnetic attraction.
(Note 2) Take special care for the magnet part not to hit against a thing (A crack or chip may occur).
(Note 3) Degree of protection is IP00. Use explosion-proof oil, etc., as necessary.
(Note 4) There is no problem on the functionality or performance even if the molded parts include sink marks or voids, etc.
4.3)
∅
Effective length
2.3)
∅
300
130
4.73)
∅
Recommended inlet/outlet
position for cooling liquid
30
20
Wire mark
(90: Cooling groove)
MT1
MT2
U
V
W
（250）
(Wire mark position)
（13）
Rotor
(TM-RBS150G20)
116
8-M6 screw
Depth 14
30
20
1
A
18.3
1
(20)
20
2
17
[Unit:mm]
8-M6 screw
Depth 14
Detail A
[Unit:mm]
8-M6 screw
Depth 14
IB-1501068-C

Advertisement

Table of Contents
loading

Related Manuals for Mitsubishi Electric CNC

Related Products for Mitsubishi Electric CNC

Table of Contents