Table of Contents
Advertisement
Direct Drive Motor Specifications and Instruction Manual
2 Specifications
2.1.5 Outline Dimension Drawings
< TM-RB Series >
[ TM-RBP012C20 ]
Power supply lead : 3-AWG18 (Finish outer diameter
（U， V， W）
Thermistor lead : 2-AWG18 (Finish outer diameter
（MT1， MT2）
Ground lead : 1-AWG18 (Finish outer diameter
Lead-out range
Recommended inlet
of lead wire
position for cooling liquid
6-M5 screw
Depth 11
Recommended outlet
position for cooling liquid
(Note 1) Do not move the stator by holding the lead wire.
(Note 2) Degree of protection is IP00. Use explosion-proof oil, etc., as necessary.
(Note 3) Continuous rated torque is assured only when the required cooling capacity is satisfied.
(Note 4) There is no problem on the functionality or performance even if the molded parts include sink marks or voids, etc.
[ TM-RBS012C20 ]
(Note 1) Deliverable rotors are magnetized. Please note the magnetic attraction.
(Note 2) Take special care for the magnet part not to hit against a thing (A crack or chip may occur).
(Note 3) Degree of protection is IP00. Use explosion-proof oil, etc., as necessary.
(Note 4) There is no problem on the functionality or performance even if the molded parts include sink marks or voids, etc.
IB-1501068-C
2.3)
∅
2.3)
∅
2.89)
∅
Effective length
300
76
(
46
: Cooling groove)
15
Wire mark
MT1
MT2
U
V
W
（250）
(Wire mark position)
（13）
Rotor
(TM-RBS012C20)
62
6-M5 screw
Depth 11
12
15
1
A
12.7
2
(15)
18
1.5
[Unit:mm]
6-M5 screw
Depth 11
Detail A
[Unit:mm]
6-M5 screw
Depth 11
Advertisement
Table of Contents
