Table of Contents
Advertisement
Configuring and Parameter Assignment the CP 440
5.1
Assigning parameters to the CP 440
Requirements
The programming interface Point–to–Point Communication, Parameter Assignment is
installed in the STEP 7 software on your PG/PC.
Before you can enter the communication processor in the configuration table of the STEP 7
software, you must have created a project and a terminal with STEP 7.
Parameter Assignment Options
You configure and assign parameters to the CP 440 using STEP 7 or the CP 440: Point-to-
Point Communication, Parameter Assignment interface.
Table 5-1
Product
CP 440
Configuration
Once you have mounted the communication processor, you must inform the programmable
controller that it is there. This process is known as "configuration".
In the following, "configuration" refers to the entry of the communication processor in the
configuration table of the STEP 7 software. In the configuration table, enter the rack, the slot
and the order number of the communication processor. STEP 7 then automatically assigns
an address to the CP.
The CPU is now able to find the communication processor in its slot in the rack by way of its
address.
Point-to-point connection CP 440 Installation and Parameter Assignment
Manual, 09/2007, A5E00057742-03
www.gkbpx.com
Configuration Options for the CP 440
Order Number
6ES7 440-1CS00-0YE0
Configurable using the parameter
assignment tool
As of version 5.1
该文档是极速PDF编辑器生成，
如果想去掉该提示,请访问并下载：
http://www.jisupdfeditor.com/
5
under STEP 7
As of version 4.0.2
65
Advertisement
Table of Contents
