Table of Contents
Advertisement
6. The first entry in the following list appears on the display:
– CLEAR P: Clear partial energy meters
– CLEAR h: Clear partial hour counter (if activated)
– CLEAR d: Clear maximum demand values (if activated)
– ET-DEF: Set all parameters to the default values.
– SETUP: Parameter programming (setup)
– INFO: Revision and checksum of internal software
– ESC: Return to normal mode
Press the "Increase" or "Decrease" key to scroll through the list.
7. Press the "Next" key to select a function.
Note
If you keep the keys pressed for longer than 60 s, the menu closes automatically.
3.4.3
Selection of measured values
Press either the "Increase" or "Decrease" key to select the measured values on the display in
the sequence shown in the table below. Each measured variable is indicated by the
corresponding symbol in the lower section of the display.
Press the "Next" key to select the display of total or single phase measurement.
The device normally displays the total values (system) indicated in the table below by the
symbol Σ. In this case, only the value and the unit of measurement appear on the screen.
If, on the other hand, the selected measurement refers to a particular phase, the symbol for
this phase (L1, L2, L3) appears in the upper section of the display.
One minute after the last key press, the display automatically switches to the screen for the
active energy total.
Note
The measurements in bold type are only displayed if you have activated the associated
activation parameter.
7KT16 energy meter
Equipment Manual, 09/2020, 2514284147-04
Description
3.4 Three-phase devices 80 A
31
Hide quick links:
Advertisement
Table of Contents
