Table of Contents
Advertisement
Figure 158. Two, Three, or Four Node Configuration UPIC Cabling
Table 21. Two, Three, or Four Node Configuration UPIC Cabling
Cable
1
2
a) To replace the UPIC cable in the system node, complete the following steps:
1) Ensure that the white plastic lock is pulled back from the plug housing.
2) Plug the UPIC cable (A) into the previously identified location in the system node by inserting
the cable into the connector until it locks into place, as shown in the following figure.
From
SC1: P1-C1-T1
SC1: P1-C2-T1
To
ND1: P1-C9-T1
ND2: P1-C10-T1
Memory modules 185
- Quick Links:
- Clock and Control Card
Hide quick links:
Advertisement
Chapters
Table of Contents
