Table of Contents
Advertisement
Parameter area initialization command
■Address
Name
Parameter area initialization command
■Description
This area is used for clearing the parameter information stored in the non-volatile memory, such as when Non-volatile memory
data error (parameter) (error code: 2010H) occurs.
Setting a fixed bit other than 0 does not cause an error.
b15
b14
b13
0
(1) 0: No command, 1: With command
If 1: With command is selected for b0, the parameter information of the non-volatile memory is initialized and the initial value
is stored in the non-volatile memory. (The initial value is set to 0: No command.)
The initial values are stored in the monitor area and parameter area after the module is powered on and off.
SLMPSND instruction
Executed by the NZ2AW1GNAL
Executed by the program
Module power supply remote reset
Address: 0402H bit 0
Parameter area initialization command
Address: 0403H bit 0
Parameter area initialization completion
Monitor area
Parameter area
Non-volatile memory
Error status flag (RX5)
APPX
162
Appendix 3 Remote Buffer Memory
b12
b11
b10
b9
ON
ON
Address
0402H
b8
b7
b6
ON
ON
OFF
Periodically read and check with the SLMPSD instruction.
Periodically read and check with the SLMPSD instruction.
Setting value A
Setting
Initial value
value A
Setting
value A
During parameter error
b5
b4
b3
b2
ON
OFF
Initial value
Initial value
Initial value
OFF
b1
b0
(1)
Advertisement
Table of Contents
Troubleshooting
