Table of Contents
Advertisement
Reset methods
■How to reset errors and alarms
The reset method differs for each error type.
Error type
Major error
Moderate error
Minor error
Alarm
• Error: Indicates an error related to the NZ2AW1GNAL settings, hardware, or CC-Link IE TSN communication.
• Alarm: Indicates an error related to AnyWireASLINK transmission.
■Error reset method by slave station command execution
This section describes how to perform an error reset by slave station command execution.
Operating procedure
1.
Select the NZ2AW1GNAL from the station list on the CC-Link IE TSN configuration window.
2.
Open the "Command Execution of Slave Station" window.
Right-click on the target NZ2AW1GNAL [Online] [Command Execution of Slave Station]
10 TROUBLESHOOTING
120
10.5 How to Check Error Codes and Alarm Codes
Error reset method
Error reset is not possible.
After clearing the cause of the error, execute one of the following.
• Turn the module power supply off and on.
• Perform a remote reset.
After clearing the cause of the error, execute one of the following.
• Turn on and off Error reset request flag (RY0).
• Turn the module power supply off and on.
• Perform a remote reset.
Advertisement
Table of Contents
Troubleshooting
