4 SET-UP AND PROCEDURE BEFORE OPERATION
192.168.3.3:80
4 - 37
(8) Automatic network connection setting at start-up
Set whether automatic network connection will be made or not at a start.
Item
No connection to network
at start-up.
Automatic connection to
network at start-up
POINT
After changing the settings, make sure to click on the "Save" button.
The settings in System setting are updated when the programmable controller is
powered off and then on, or the CPU module is reset.
REMARKS
(1) The following table indicates the default IP address of the Web server module.
( 1) ( 2)
Item
IP address
Subnet mask
1
When making initial setting, set the IP addresses of the Web server module
and personal computer to the same network address.
2
Prior to shipment, the Web server module is set as indicated below,
including the above default IP address.
Connecting through LAN or the router.
Use the default HTTP port number (80).
Use the default FTP port number (21).
System name: QJ71WS96
Do not execute network diagnoses (ping).
Automatic connection to network at start-up.
(2) NAT is shown below.
Internet
202.200.10.3:80
Router
Network connection/disconnection processing is required when
continuous connection is not available. (Refer to Section 5.4)
The Web server module automatically connects to the network at a
start.
192.168.3.3
255.255.255.0
Conversion table
202.200.10.3:80
192.168.3.3:80
192.168.3.1:10080
MELSEC-Q
Description
Description
The packet addressed to "202.200.10.3:80" is
sent after conversion of the address into
"192.163.3.3:80" by the router.
4 - 37