Mitsubishi Electric MELSEC Q Series User Manual page 191

Programmabale web server module

Hide thumbs Also See for MELSEC Q Series:

Table of Contents

4 SET-UP AND PROCEDURE BEFORE OPERATION

Removal/Replacement of CompactFlash card

Stop file access and disable read from/write to

CompactFlash card. (Refer to Section (1))

Remove CompactFlash card.

(Refer to Section (4))

Insert a new CompactFlash card.

(Refer to Section (3))

Cancel file access stop and enable read from/write to

CompactFlash card. (Refer to Section (2))

[Removing or Replacing the CompactFlash Card]

Before removing or replacing the CompactFlash card, be sure to stop the file

access by the following procedures.

Is power ON?

Failure to observe the above procedure may cause erasure of logging data during

processing, corruption of data in the CompactFlash card during access, or a file

system fault.

For a CompactFlash card fault, refer to Section 9.1 (9).

(1) Stopping file access

Stop a file access.

Turn File access stop request (Y2) from OFF to ON.

Confirm that file access has stopped.

CompactFlash card setting status (X1) is OFF.

File access status (X2) is ON.

Turn File access stop request (Y2) from ON to OFF.

Turn programmable controller ON.

Turn programmable controller OFF.

Melsec qj71ws96