Siemens ST950/ Plus+ Installation Method Statement page 13

Controller cabinet stool

Hide thumbs Also See for ST950/ Plus+:

Table of Contents

Controller

Cabinet

Method Statement

Grease on studs

There should be some grease on each stud, please make sure it is there. If there is no grease then it is very

likely that the nut could cease making in unremovable in the future. If there is no grease then please apply

either carbon grease or copper grease to the stud.

3. Tighten down the nuts on the top clamp. Tighten each nut a little at a time so that the force

is distributed evenly across the plate. This will minimise any side loads from being applied to

the top clamp. Tighten until the bottom clamp touches the base plate.

4. Terminate the cables in the cabinet.

5. Replace the stool door.

Shim

suit

different cable

diameters.

Figure 8 – Plus+ Sealed Base Kit Components and Earthing Mechanism

Controller Cabinet Stool Installation

Method Statement

Stool

Installation

Page 13 of 13

667/CC/53060/000

Issue 1

Unrestricted

Table of Contents