Setting The Unit's Operational Mode; Stack Management; Configuring The Stack Master And Unit Id - Cisco SGE2000 Administration Manual
Gigabit ethernet switch release 1.0
Hide thumbs
Also See for SGE2000:
- Reference manual (286 pages) ,
- Quick installation manual (32 pages) ,
- Datasheet (5 pages)
Table of Contents
Advertisement
Setting the Unit's Operational Mode
Use the GUI to set the unit's operational mode to standalone or stack. This configuration
takes effect after the next reboot.
Configuring the Stack Master and Unit ID
Stack Management
The Stack Management Page allows network managers to either reset the entire stack or a
specific device. Device configuration changes that are not saved before the device is reset
are not saved. If the Stack Master is reset, the entire stack is reset.
To open the Stack Management Page:
1.
Click System > System Management > Stack Management.
opens:
21
The Stack Management Page
Linksys One Ready Communications Solution
Chapter 3: Connecting the Switch
Configuring Units and Ports
3
Hide quick links:
Advertisement
Table of Contents
