hit counter script

Control Rod Adjustment - Toro ProLine 30341 Operator's Manual

Mid–size mower proline hydro 17 hp with 52 in. side discharge mower
Table of Contents

Advertisement

1
Figure 42
1. Hydro control linkage
2. Front nut
Note: If inconsistent neutral occurs, check to be sure both
springs are properly tightened on the speed control lever
under the console, especially the rear pivot spring. Repeat
above adjustments if necessary (Fig. 43).
1
3
Figure 43
1. Speed control lever
2. Rear pivot spring
Right Side Linkage Adjustment
1. Place the speed control lever in the neutral position.
2. Place the right drive lever in the full forward position.
3. Hold OPC levers down.
Note: The OPC levers must be held down whenever the
speed control lever is out of the neutral position or the
engine will kill.
4. Adjust the right side linkage by turning the quick track
knob counter–clockwise until the tire begins to rotate
forward (Fig. 44).
3
2
m–5394
3. Rear adjusting nut
2
m–5396
3. spring
37
5. Turn the knob clockwise 1/4 of a turn at a time. Then
move the speed control forward and back to neutral.
Repeat this until right wheel stops rotating forward
(Fig. 44).
6. The spring that keeps tension on the knob should
normally not need adjustment. However if adjustment
is needed, adjust the length of spring to 1 in. (26 mm)
between the washers (Fig. 44).
7. Adjust spring length by turning nut at front of spring
(Fig. 44).
1
Figure 44
1. Hydro control linkage
2. Quick track knob

Control Rod Adjustment

Checking Control Rod
1. With rear of machine still on jack stands and engine
running at full throttle, move the speed control lever to
the medium speed position.
Note: The OPC levers must be held down whenever the
speed control lever is out of the neutral position or the
engine will kill.
2. Move the respective drive lever upward until it reaches
the neutral position and engage neutral locks.
3. If the tire rotates in either direction, the length of the
control rod will need to be adjusted.
Adjusting Control Rods
1. Adjust the rod length by releasing the drive lever and
removing clevis pin. Rotate the rod in the rod fitting
(Fig. 45).
3
2
4
m–5403
3. Spring
4. 1 inch (26 mm)

Advertisement

Table of Contents
loading

Table of Contents