Activate An Ac Power Supply Module - Cisco NCS 540 Hardware Installation Manual
Large density routers
Hide thumbs
Also See for NCS 540:
- Installation manual (62 pages) ,
- Prepare for installation (14 pages) ,
- Manual (14 pages)
Table of Contents
Advertisement
Install the Device
2. Insert the power supply cord into the tie [1, 3] and tighten the tie around the power supply cord as shown
in [2, 4] in the figure below.
Figure 19: Attach the AC Power Tie-and-Clip Cord
Note
These images are for only representation purposes.
Activate an AC Power Supply Module
Perform the following procedure to activate an AC power supply:
Step 1
Plug the power cord into the power supply.
Step 2
Connect the other end of the power cord to an AC-input power source.
Step 3
Verify power supply operation by checking if the respective power supply front panel LED (PS0 or PS1) is green.
Step 4
If the LEDs indicate a power problem, see Troubleshooting for troubleshooting information.
Step 5
If you are also connecting a redundant AC power supply, repeat these steps for the second power source.
Note
If you are connecting a redundant AC power supply, ensure that each power supply is connected to a separate
power source in order to prevent power loss in the event of a power failure.
Cisco Network Convergence System 540 Large Density Routers Hardware Installation Guide
Activate an AC Power Supply Module
37
Hide quick links:
Advertisement
Table of Contents
