Connecting A Cable To The Output 10Mhz Or 1Pps Interface; Connecting A Cable To The Gnss Antenna Interface - Cisco NCS 540 Hardware Installation Manual
Large density routers
Hide thumbs
Also See for NCS 540:
- Installation manual (62 pages) ,
- Prepare for installation (14 pages) ,
- Manual (14 pages)
Table of Contents
Advertisement
Connecting a Cable to the Output 10MHz or 1PPS Interface
Connecting a Cable to the Output 10MHz or 1PPS Interface
Step 1
Connect one end of a mini-coax cable to the Slave unit.
Step 2
Connect the other end of the mini-coax cable to the 10MHz or 1PPS port of the router.
Connecting a Cable to the GNSS Antenna Interface
1. Connect one end of a shielded coaxial cable to the GNSS RF IN port.
2. Connect the other end of the shielded coaxial cable to the GNSS antenna after the primary protector.
Note
The GNSS RF In port should have a primary protector installed to meet the Local Safety guidelines.
The GNSS RF In coaxial cable shield must be connected to the Facility Equipment Ground through the
chassis. The chassis must have the ground wire connected to the Facility Equipment Ground.
Figure 25: GNSS Receiver
Cisco Network Convergence System 540 Large Density Routers Hardware Installation Guide
44
Install the Device
Hide quick links:
Advertisement
Table of Contents
