Table of Contents
Advertisement
14. Install the chassis cover. For instructions, see
15. Plug all peripheral devices and the AC power cable back into the server.
Removing a PCI Riser Connector
The PCI riser connector can be replaced if it fails or if a different option is required. To replace the PCI riser
connector, use the following instructions to remove it, and then follow the instructions under
Riser Connector"
to install a new riser connector.
NOTE: NOTE: To eliminate the possibility of installing the replacement connector on the wrong side of the PCI
riser assembly, replace one connector at a time.
1.
Observe the safety and ESD precautions at the beginning of this book. See
2.
Power down the server and unplug all peripheral devices and the AC power cable.
3.
Remove the chassis cover. For instructions, see
4.
Lift up on the two blue levers to lift the PCI riser assembly from the chassis.
5.
Remove any PCI add-in cards that are installed in the connector. For instructions, see "Removing a PCI
Add-in Card."
6.
Push back on the blue release lever at the end of the riser connector. While holding the lever back, push
firmly on the other edge of the board to disengage the board from the riser.
7.
Follow the steps under "Installing a PCI Riser
8.
Install the chassis cover. For instructions, see
Chapter 3
"Installing the Chassis Cover."
"Removing the Chassis Cover."
Connector"
to install a replacement riser connector.
"Installing the Chassis Cover."
"Installing a PCI
"Safety Information."
86
Advertisement
Table of Contents
