Table of Contents
Advertisement
C
leaning and Maintenance
Cleaning the Inside of your Washer
If you use fabric softener or do regular COLD water washing, it is very important that you occasionally clean the
inside of your washer.
• Fill your washer with HOT water.
• Add about two cups of a powdered Detergent that contains phosphate.
• Let it operate for several minutes.
• Stop the washer, open the lid and leave it to soak overnight.
• After soaking, drain the washer and run it through a normal cycle.
Or use TUB CLEAN PROGRAM periodically.
We do not recommend that you wash clothes during this procedure.
Products that might damage your washing machine
• Concentrated bleaches and diaper sanitizer will cause damage to the paintwork and components of your washer.
• Hydrocarbon solvents i.e. petrol, paint thinners and lacquer thinners, etc. can dissolve plastic and blister paint
(Be careful when washing garments stained with these solvents as they are flammable DO NOT put them in
washer or dryer.)
• Some pretreatment sprays or liquids can damage your washer's control panel.
• Use of dyes in your washer may cause staining of the plastic components. The dye will not damage the machine
but we suggest you thoroughly clean your washer afterwards. We do not recommend the use of dye strippers in
your washer.
• Do not use your washer lid as a work surface.
U
se of Handle Locker
You can use handle hold function if you like to use.
Handle hold function is operated by holder under the handle.
• Slide holder to left/right side until
you listen to "Click" sound to
holding handle.
• Do opposite to loose the Handle
handing .
NOTE
While operating the Lid Door, always conrm that Handle Lock is in Fixed position as shown in below
•
picture because if it is not locked completely then there is Risk of falling objects.
If Lid Door is closed while Handle is not completely locked, "dE" error may occur during operation.
•
If possible, It is always recommended to use handle in Locked state.
•
Lock
<
S
a t
e t
o
f f
x i
n i
g
h
n a
d
e l
>
39
Unlock
<
S
a t
e t
f o
u
f n
x i
n i
g
h
n a
d
e l
>
- Quick Links:
- Read this Manual
- Leaning and Maintenance
Hide quick links:
Advertisement
Table of Contents
