Cisco Nexus 9504 Hardware Installation Manual page 32

Nx-os mode switch

Hide thumbs Also See for Nexus 9504:

Table of Contents

Grounding the Chassis

• Grounding lug—A two-holed standard barrel lug that supports up to 6 AWG wire. This lug is supplied

• Grounding screws—Two M4 x 8 mm (metric) pan-head screws. These screws are shipped with the

• Grounding wire—Not supplied with the accessory kit. This wire should be sized to meet local and

• Number 1 Phillips-head torque screwdriver.

• Crimping tool to crimp the grounding wire to the grounding lug.

• Wire-stripping tool to remove the insulation from the grounding wire.

Step 1

Use a wire-stripping tool to remove approximately 0.75 inch (19 mm) of the covering from the end of the grounding

wire.

Cisco Nexus 9504 NX-OS Mode Switch Hardware Installation Guide

with the accessory kit.

accessory kit.

national installation requirements. Depending on the power supply and system, a 12 AWG to 6 AWG

copper conductor is required for U.S. installations. We recommend that you use commercially available

6 AWG wire. The length of the grounding wire depends on the proximity of the switch to proper grounding

facilities.

Installing a Chassis

Table of Contents