Table of Contents
Advertisement
8
CAUTION
•
Install the product where no Electromagnetic Interference occurs.
•
If you install the product in a place that does not meet the recommended conditions, this may cause serious damage
to the product's picture quality, life cycle, and appearance. Please check with service engineer before installing. Please
do not install the product in places such as where there is an abundance of fine dust or oil mist, chemical substances
are used, the temperature is very high or low, the humidity is very high.
•
Make sure the product is well ventilated by Installing at a distance from the wall.
- If you install the product too close to the wall, it may be deformed or fire can break out due to internal heat buildup.
•
Do not cover the product with tablecloth or curtain or other material (eg. plastic) while plugged in to block the
ventilation hole of the product.
- The product can be deformed or fire can break out due to overheating inside the product.
•
Do not install the product in an area with poor ventilation (e.g. on a bookshelf, in a closet) or outside and avoid placing
on cushions or carpets.
- The product could catch fire due to overheating inside the product.
•
Install the product on a flat and stable place that is large enough to support the product.
- If the product is dropped, you may be injured or the product may be broken.
•
When installing the product on a shelf or cabinet, make sure that the bottom end of the product is not protruding
forward.
- The product may fall due to unbalanced center of gravity, which may cause personal injury or damage to the
product. Be sure to use cabinets or shelves that fit your product.
•
A readily accessible disconnect device shall be incorporated external to the product.
•
Set to [Screen Off & Backlight On] when installing outdoors.
-
Enable the outdoor mode to reduce the risk of the internal humidity and condensation.
•
When operating in below zero temperature, the enclosure may not work for up to one hour to raise the internal
temperature of the enclosure.
-
The components complied with the requirements of IEC 61643-series shall be installed internal or external to this
product.
Advertisement
Table of Contents
