Review The Network Deployment And Default Configuration - Cisco Firepower 2100 Getting Started Manual
Hide thumbs
Also See for Firepower 2100:
- Getting started manual (232 pages) ,
- Manual (44 pages) ,
- Getting started manual (178 pages)
Table of Contents
Advertisement
Review the Network Deployment and Default Configuration
Pre-Configuration
Pre-Configuration
Pre-Configuration
ASA CLI
ASA CLI
FXOS CLI
Firepower Chassis
Manager
Firepower Chassis
Manager
ASDM
Cisco Commerce
Workspace
Smart Software Manager
ASDM
ASDM
ASDM
Firepower Chassis
Manager
Review the Network Deployment and Default Configuration
The following figure shows the default network deployment for the Firepower 2100 using the default
configuration in ASA Platform mode.
Cisco Firepower 2100 Getting Started Guide
190
Review the Network Deployment and Default Configuration, on page
Cable the Device, on page
193.
Power on the Device, on page
Enable Platform Mode, on page
(Optional) Change the FXOS and ASA Management IP Addresses or Gateway, on page
Change the Management IP: ASA.
(Optional) Change the FXOS and ASA Management IP Addresses or Gateway, on page
Change the Management IP: FXOS.
(Optional) Log Into the Firepower Chassis Manager, on page
(Optional) Enable Additional Interfaces in the Firepower Chassis Manager, on page
Log Into ASDM, on page
206.
Configure Licensing, on page
Configure Licensing, on page
Configure Licensing, on page
Configure the ASA, on page
(Optional) Configure Management Access for FXOS on Data Interfaces, on page
FXOS remote management; allow FXOS to initiate management connections from an ASA
interface.
(Optional) Configure Management Access for FXOS on Data Interfaces, on page
access lists to allow your management addresses; enable SNMP (HTTPS and SSH are enabled
by default); .
194.
195.
206: Obtain feature licenses.
206: Generate a license token for the chassis.
206: Configure feature licenses.
211.
ASA Deployment with ASDM
190.
197:
197:
203.
203.
213: Enable
213: Configure
Advertisement
Chapters
Table of Contents
