Cisco Firepower 2100 Getting Started Manual page 44
Hide thumbs
Also See for Firepower 2100:
- Getting started manual (232 pages) ,
- Manual (44 pages) ,
- Getting started manual (104 pages)
Table of Contents
Advertisement
Complete the FTD Initial Configuration Using the CLI
firepower login: admin
Password: Admin123
Successful login attempts for user 'admin' : 1
[...]
Hello admin. You must change your password.
Enter new password: ********
Confirm new password: ********
Your password was updated successfully.
[...]
firepower#
Step 3
If you connected to FXOS on the console port, connect to the FTD CLI.
connect ftd
Example:
firepower# connect ftd
>
Step 4
The first time you log in to FTD, you are prompted to accept the End User License Agreement (EULA) and,
if using an SSH connection, to change the admin password. You are then presented with the CLI setup script.
Note
Defaults or previously entered values appear in brackets. To accept previously entered values, press Enter.
See the following guidelines:
• Enter the IPv4 default gateway for the management interface—The data-interfaces setting applies
only to remote FMC or Firepower Device Manager management; you should set a gateway IP address
for Management 1/1 when using FMC on the management network. In the edge deployment example
shown in the network deployment section, the inside interface acts as the management gateway. In this
case, you should set the gateway IP address to be the intended inside interface IP address; you must later
use FMC to set the inside IP address.
• If your networking information has changed, you will need to reconnect—If you are connected with
SSH but you change the IP address at initial setup, you will be disconnected. Reconnect with the new
IP address and password. Console connections are not affected.
• Manage the device locally?—Enter no to use FMC. A yes answer means you will use Firepower Device
Manager instead.
• Configure firewall mode?—We recommend that you set the firewall mode at initial configuration.
Changing the firewall mode after initial setup erases your running configuration.
Example:
You must accept the EULA to continue.
Press <ENTER> to display the EULA:
Cisco Firepower 2100 Getting Started Guide
42
You cannot repeat the CLI setup wizard unless you clear the configuration; for example, by reimaging.
However, all of these settings can be changed later at the CLI using configure network commands.
See the
FTD command
reference.
Firepower Threat Defense Deployment with FMC
Advertisement
Chapters
Table of Contents
