Husqvarna 143R-II Operator's Manual page 17
Hide thumbs
Also See for 143R-II:
- Operator's manual (268 pages) ,
- Operator's manual (196 pages) ,
- Operator's manual (216 pages)
Table of Contents
Advertisement
Available languages
Available languages
To make the fuel mixture
Note:
Always use a clean fuel container when you mix
the fuel.
Note:
Do not make more than 30 days quantity of fuel
mixture.
1. Add half of the gasoline quantity.
2. Add the full quantity of oil.
3. Shake the fuel mixture to mix the contents.
4. Add the remaining gasoline quantity.
5. Shake the fuel mixture to mix the contents.
6. Fill the fuel tank.
To add fuel
WARNING:
objects near fuel. Before you add fuel, stop
the engine and let it cool for minutes.
WARNING:
the fuel tank cap slowly to release unwanted
pressure.
WARNING:
the fuel tank cap carefully. Move the
machine away from the refuelling area and
the power before you start the engine.
•
Always use a fuel container with an anti-spill valve.
•
Make sure that the area near the fuel tank cap
is clean. Contamination in the tank can cause
operating problems.
•
Shake the fuel container before you add the fuel
mixture to the fuel tank.
To start and stop
Before you operate the product
•
Examine the work area to make sure that you know
the type of terrain, the slope of the ground and if
there are obstacles such as stones, branches and
ditches.
•
Do an overhaul inspection of the product.
•
Do the safety inspections, maintenance and
servicing that are given in this manual.
•
Make sure that all covers, guards, handles and the
cutting equipment are correctly attached and not
damaged.
1334 - 005 - 22.02.2022
Do not smoke or put hot
When you add fuel, open
After you add fuel, tighten
•
Make sure that there are no cracks at the bottom of
the saw blade or grass blade teeth or by the center
hole of the blade. Replace the blade if it is damaged.
•
Examine the support flange for cracks. Replace the
support flange if it is damaged.
•
Make sure that the locknut can not be removed by
hand. If you can remove it by hand, it does not
lock the cutting attachment sufficiently and you must
replace it.
•
Examine the blade guard for damages or cracks.
Replace the blade guard if it has been hit or if it has
cracks.
•
Examine the trimmer head and cutting attachment
guard for damages or cracks. Replace the trimmer
head and cutting attachment guard if they have been
hit or if they have cracks.
To start a cold engine
1. Move the stop switch to the start position.
17
Advertisement
Chapters
Table of Contents
