Husqvarna 143R-II Operator's Manual page 15
Hide thumbs
Also See for 143R-II:
- Operator's manual (268 pages) ,
- Operator's manual (196 pages) ,
- Operator's manual (40 pages)
Table of Contents
Advertisement
Available languages
Available languages
3. Turn the output shaft until 1 of the holes in the drive
disc aligns with the hole in the gear housing.
4. Put the locking pin or hex key (C) into the hole to
lock the shaft.
5. Put the blade (D), support flange (E) and support
cup (F) on the output shaft.
6. Install the nut (G). Use the combination wrench and
tighten the nut to torque 35-50 Nm. Hold the shaft of
the combination wrench as near the blade guard as
possible.
7. To tighten the nut, turn the combination wrench in
the opposite direction to the direction of rotation.
Note:
Left hand thread.
To attach the trimmer guard and the trimmer
head
Note:
Make sure to use the correct trimmer guard for
the correct trimmer head.
1. Attach the correct trimmer guard/combination guard
(A) for the trimmer head.
2. Hang the trimmer guard/combination guard (A) on
the 2 hooks on the plate holder (M).
3. Install the trimmer guard/combination guard around
the shaft and tighten it with the bolt (L). Use the
locking pin or hex key (C).
L
M
A
4. Put the locking pin or hex key (C) in the groove on
the screw head and tighten.
5. Attach the drive disc (B) and support flange (E) on
the output shaft.
1334 - 005 - 22.02.2022
H
E
C
B
M
L
6. Turn the output shaft until one of the holes in the
drive disc aligns with the hole in the gear housing.
7. Install the locking pin or hex key (C) in the hole to
lock the shaft.
H
8. Assemble the trimmer head/plastic blades (H). Turn
the trimmer head/plastic blades counterclockwise.
9. To disassemble, follow the instructions in the
opposite sequence.
To install the transport guard
1. Install the blade in the transport guard (A).
2. Put the two fasteners (B) into the slots (C) to attach
the transport guard.
B
A
To install the 2-teeth blade in the guard
1. Install the blade in the transport guard.
A
To adjust the harness
WARNING:
be correctly attached to the harness. Do not
use a defective harness.
1. Put on the harness.
2. Connect the product to the harness.
3. Adjust the harness for the best work position.
H
C
The product must always
15
Advertisement
Chapters
Table of Contents
