Wireless Interface Module (Wim); Gigabit Ethernet Combo Port; Gigabit Ethernet Copper Ports; Power Over Ethernet - Cisco Catalyst IR1800 Rugged Series Hardware Installation Manual
Hide thumbs
Also See for Catalyst IR1800 Rugged Series:
- Installation manual (96 pages) ,
- Connecting (4 pages) ,
- Installation manual (92 pages)
Table of Contents
Advertisement
Product Overview
For the most up-to-date list of supported SFP models for Cisco Industrial Devices, see the
Optics-to-Device Compatibility
Wireless Interface Module (WIM)
The Wireless Interface Module (WIM)
Complete details on the WIM are found in this chapter:
Gigabit Ethernet Combo Port
The IR1800 supports a single combo fiber and copper port (SFP/RJ45). The SFP supports standard 1000Base-X
or 100Base-FX Ethernet over single-mode or multi-mode optics. Industrial SFPs must be used for the system
to meet the operating temperature from -40C to +60C. If commercial or extended temperature grade of SFP
is used, the system's operating temperature must be derated.
Gigabit Ethernet Copper Ports
The IR1800 has four RJ-45 copper ports. These copper ports support standard 3-speed, 10/100/1000Base-T
Ethernet features, including automatic medium-dependent interface crossover (auto-MDIX), forced or auto
negotiation of speed and duplex, fast link drop, and cable diagnostics.
Power over Ethernet
A 30.8W capacity PoE PSE power supply is built into the IR1800. The power supply can power any of the
LAN switch ports that are compliant with PoE and PoE+ 802.3af and 802.3at Powered Device (PD)
specification, subject to 30.8 W maximum power shared among all ports.
Front Panel LEDs
The following figure shows the locations of the LEDs.
Matrix.
Cisco Wi-Fi Interface Module (WIM), on page 57
Cisco Catalyst IR1800 Rugged Series Router Hardware Installation Guide
Wireless Interface Module (WIM)
Cisco
17
- Quick Links:
- Cisco Ir1821 Router
- Cisco Ir1835 Router
Hide quick links:
Advertisement
Table of Contents
