Table of Contents
Advertisement
Wireless-N Gigabit Router with Storage Link
Follow these steps to set DMZ hosting:
1. Access the Router's web-based utility by going to http://192.168.1.1 or the IP address of the Router.
Go to the Applications & Gaming => Port Range Forwarding tab.
2. Disable or remove the entries you have entered for forwarding. Keep this information in case you
want to use it at a later time.
3. Go to the Applications & Gaming => DMZ tab.
4. Select Enabled next to DMZ. For the computer you want exposed to the Internet, specify it by IP
address or MAC address. If you use its IP address, select Destination IP Address, and enter its IP
address the Destination IP Address field. If you use its MAC address, select Destination MAC
Address, and enter its MAC address in the Destination MAC Address field. Please refer to "Appendix
E: Finding the MAC Address and IP Address for Your Ethernet Adapter" for details on getting an IP
address. If you assigned a static IP address to the computer, then you can click the DHCP
Reservation button on the Basic Setup screen to look up its static IP address.
5. Once completed with the configuration, click the Save Settings button.
9. I forgot my password, or the password prompt always appears when I am saving settings to the
Router.
Reset the Router to factory default by pressing the Reset button for five seconds and then releasing it. If you
are still getting prompted for a password when saving settings, then perform the following steps:
1. Access the Router's web-based utility by going to http://192.168.1.1 or the IP address of the Router.
Enter the default password admin, and click the Administration => Management tab.
2. Enter a different password in the Router Password field, and enter the same password in the second
field to confirm the password.
3. Click the Save Settings button.
10. I am a PPPoE user, and I need to remove the proxy settings or the dial-up pop-up window.
If you have proxy settings, you need to disable these on your computer. Because the Router is the gateway for
the Internet connection, the computer does not need any proxy settings to gain access. Please follow these
directions to verify that you do not have any proxy settings and that the browser you use is set to connect
directly to the LAN.
• For Microsoft Internet Explorer 5.0 or higher:
1. Click Start, Settings, and Control Panel. Double-click Internet Options.
2. Click the Connections tab.
3. Click the LAN settings button and remove anything that is checked.
4. Click the OK button to go back to the previous screen.
5. Click the option Never dial a connection. This will remove any dial-up pop-ups for PPPoE users.
• For Netscape 4.7 or higher:
1. Start Netscape Navigator, and click Edit, Preferences, Advanced, and Proxies.
2. Make sure you have Direct connection to the Internet selected on this screen.
3. Close all the windows to finish.
Appendix A: Troubleshooting
Common Problems and Solutions
60
Advertisement
Table of Contents
Related Manuals for Cisco Linksys WRT350N
Related Products for Cisco Linksys WRT350N
- Cisco Linksys WRT610N
- Cisco WRT54G2-RM - Refurb WRT54G2WIRELESS G Broadband Rtr Id No Rtns
- Cisco WRT54G2-CA - Wireless-G Broadband Router Wireless
- Cisco LINKSYS WRT54GX4
- Cisco Linksys WRT54GS2
- Cisco WRT610N - Simultaneous Dual-N Band Wireless Router
- Cisco WRT320N - Wireless-N Gigabit Router Wireless
- Cisco WRV210 - Wireless-G VPN Router