Table of Contents
Advertisement
Thermal cover
Remove the LCD module
Make sure the following FRUs (CRUs) have been removed.
"Remove the lower case" on page 28
"Remove the battery pack" on page 29
"Remove the solid-state drive" on page 31
"Remove the side I/O bracket" on page 32
"Remove the rear I/O bracket" on page 33
"Remove the heat sink" on page 35
"Remove the antenna module" on page 40
"Remove the system board" on page 45
"Remove the thermal cover" on page 47
Step 1.
Remove eight screws.
Figure 32. Remove eight screws
Screw specifications
M2 x L3.5
Step 2.
Rotate the LCD module to an angle of more than 90 degrees and remove the LCD module.
48
ThinkBook Plus Gen 3 Hardware Maintenance Manual
Number of screws
8
Advertisement
Table of Contents
