Table of Contents
Advertisement
Provisioning Using ASH and SNMP
This chapter discusses the provisioning procedures for the Cisco ONS 15216 EDFA2 using SNMP and
a proprietary command line interface named the ASH shell. See
for provisioning information using TL1 commands in the TL1 shell.
The provisioning procedure for the ONS 15216 EDFA2 in the ASH shell is as follows:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
The following sections describe these steps in detail.
4.1 Log In via RS-232 (EIA/TIA-232) Port Using HyperTerminal
Logging in through the RS-232 (EIA/TIA-232) port is required to set the ONS 15216 EDFA2 IP address
before there can be access via the LAN port. (See
on page
Connect to the RS-232 (EIA/TIA-232) port on the front panel. See
Step 1
section on page 3-7
Open HyperTerminal. (HyperTerminal can be found in the Microsoft Windows Accessories menu.)
Step 2
78-16033-01
F I N A L D R A F T - C I S C O C O N F I D E N T I A L
Log In via RS-232 (EIA/TIA-232) Port Using HyperTerminal, page 4-1
Set IP Address, page 4-3
Log In via LAN Port Using Telnet (Optional), page 4-3
Set Date and Time, page 4-4
Set Power Bus Mode (Simplex or Duplex), page 4-4
Verify Amplifier Operational Status, page 4-4
Set Gain, page 4-5
Set Alarm Thresholds, page 4-5
Set Password, page 4-10
Add Users, page 4-11
Save Changes, page 4-11
Log Off, page 4-12
Back Up System Configuration, page 4-12
Restore System Configuration, page 4-13
Recover Default Password, page 4-14
4-3.)
for line connection and HyperTerminal setup instructions.
C H A P T E R
Chapter 8, "Provisioning Using TL1"
"Log In via LAN Port Using Telnet (Optional)" section
"Serial Connection Procedure"
Cisco ONS 15216 EDFA2 Operations Guide
4
4-1
Advertisement
Table of Contents
Troubleshooting
