Prp Console Port Signals - Cisco 12416 Installation And Configuration Manual
Cisco systems bridge/router installation and configuration guide
Hide thumbs
Also See for Cisco 12416:
- Replacement instructions manual (32 pages) ,
- Unpacking instructions manual (28 pages) ,
- Instructions manual (16 pages)
Table of Contents
Advertisement
Chapter 2
Preparing for Installation
PRP Console Port Signals
OL-11495-01
The PRP console port is a DCE RJ-45 interface for connecting a terminal to the
router. The console port does not support modem control or hardware flow control
and requires a roll-over RJ-45 cable.
Before connecting a terminal to the console port, check the terminal setting for
the data transmission rate, in bits per second (bps). The terminal transmission rate
setting must match the default rate of the PRP console port, which is 9600 bps.
Set the terminal to these operational values: 9600 bps, 8 data bits, no parity, 2 stop
bits (9600 8N2).
Table 2-9
lists the signals used on the console port.
Table 2-9
PRP Console Port Signals (with RJ45 roll-over cable)
Console Port Pin
Signal
1
1
—
2
DTR
3
TxD
4
GND
5
GND
6
RxD
7
DSR
1
8
—
1. These pins are not connected.
Cisco 12016, Cisco 12416, and Cisco 12816 Router Installation and Configuration Guide
PRP Port Connection Guidelines
Input/Output
Description
—
—
Output
Data terminal ready
Output
Transmit data
—
Signal ground
—
Signal ground
Input
Receive data
Input
Data set ready
—
—
2-39
Advertisement
Table of Contents
Troubleshooting
