Connect The Shared Port Adapter Cables; Install The Cables In The Cable-Management Bracket - Cisco Router ASR 1006 Hardware Installation Manual

Cisco systems router quick start guide

Hide thumbs Also See for Router Cisco ASR 1006:

Table of Contents

Connect to the port using the RJ-45-to-RJ-45 cable and RJ-45-to-DB-25 DTE adapter or using the

–

RJ-45-to-DB-9 DTE adapter.

Figure 8

Management Ethernet Port Connectors

AUXiliary connection

MGMT Ethernet port

Insert an Ethernet RJ-45 cable into the MGMT ETHERNET port.

Step 3

Insert the other end of the RJ-45 cable to your management device or network.

Step 4

Configure to a fixed speed through the command line interface (CLI) commands.

Step 5

Connect the Shared Port Adapter Cables

The instructions for connecting the cables for the shared port adapter installed in the Cisco ASR 1006 Router are contained in

the

Cisco ASR 1000 Series Aggregation Services Routers SPA and SIP Hardware Installation

No specific card level cable-management will be provided on the SIP carrier cards. SPAs utilize the SPA cable-management

brackets that are provided with each SPA as part of their accessory kits. Cables coming off the front side of the SPAs and SIPs

utilize the chassis level cable-management brackets provided on the chassis rack mount brackets (see

To secure shared port adapter interface cables and input or output cables connected to the Cisco ASR 1006 Router, follow these

steps:

SPA -4XO C3-P

BITS port

Cable-management U feature device

SPA -4XO C3-P

Guide.

Figure

8).

Table of Contents